In the last article we told about a new technology of the distributed storage that appeared in Windows Server 2016 – Storage Spaces Direct (S2D). S2D allows to create a network failover distributed virtual data storage on the local disks of cluster servers (see the article). In this article, we’ll show you how to detect and replace a failed physical disk in an S2D cluster.

I remind you that in S2D you can create a Mirror type storage (similar to RAID 1): in a 2-disk configuration (not recommended), this storage can survive a failure of any disk, and if there are 3 or more disks in a pool, 2 disks may fail without any consequences. The second type of the array is Parity (similar to RAID 5). In the configuration consisting of three disks, an array can lose one disk without any consequences, if there are seven disks, 2 of them may fail at a time.

You can check the status of the storage subsystem of an S2D cluster using this command:

Get-StorageSubSystem *Cluster* | Get-StorageJob

You can find a fault with one of the disks in a storage pool using the GUI in the Failover Cluster Manager (Storage ->Storage Pool). As you can see, one of the physical disks in the pool is in the Unhealthy state.

You can get the information about the status of the disks in a pool using PowerShell:

Get-StoragePool *S2D* | Get-PhysicalDisk

Save the object of the problem disk into a variable, for example, like this:

$Disk = Get-PhysicalDisk |? OperationalStatus -Notlike ok

Prevent further write attempts to this disk:

Set-PhysicalDisk -InputObject $Disk -Usage Retired

Try to remove the failed disk from the storage pool:

Get-StoragePool *S2D* | Remove-PhysicalDisk –PhysicalDisk $Disk

Soon a warning will appear that this device doesn’t respond.

To make it easier to identify a disk in a server rack, enable LED light of a disk:

Get-PhysicalDisk |? OperationalStatus -Notlike OK | Enable-PhysicalDiskIdentification

Now go to the server room and find a problem disk using the backlight enabled earlier.

Replace a failed disk with a new one.

You can now turn off the backlight:

Get-PhysicalDisk |? OperationalStatus -like OK | Disable-PhysicalDiskIdentification

Make sure that the OS has detected the new disk:

$Disk = Get-PhysicalDisk | ? CanPool –eq True