In VMware vSphere, you can use an iSCSI disk as a shared datastore for your ESXi hosts. An ESXi host accesses iSCSI storage over your local network using the TCP protocol. In this article, we’ll look at how to add an iSCSI LUN to a VMWare ESXi host and create a shared VMFS datastore on it.

Suppose you have already created, configured, and published an iSCSI target (disk) on your storage device (array). Also, you can use a virtual disk (VHDX) hosted on Windows Server as an iSCSI target.

In this example, we are using a standalone host running VMware ESXi 6.7 (you can also use the free ESXi Hypervisor). This can be a physical host or a virtual machine (here is an example of running ESXi in a Hyper-V VM). There are two network interfaces in the host (the first is for management and the second is for the iSCSI traffic).

Configure Network for iSCSI Traffic on VMWare ESXi

Open the web interface to manage your ESXi host (_https://YOUR_ESXI_HOST/ui/#/login).

First of all, create a separate VMkernel network interface that will be used by the ESXi host to access the iSCSI storage. Open Networking -> VMkernel NICs -> Add VMkernel NIC.

Besides the vmk port, create a new port group (New port group). Specify the group name (iSCSI) and assign a static IP address for your vmkernel interface.

Then open the settings of your default vSwitch0 (Networking -> Virtual Switches). Make sure that the second physical interface (vmnic1) of your host has been added to the configuration and is active (otherwise, click Add uplink to add it).

In the NIC Teaming section, make sure that both physical interfaces are Active.

Then in the iSCSI port group settings, you need to allow only the second interface to be used for iSCSI traffic. Go to Networking -> Port groups -> iSCSI —> Edit settings. Expand the NIC teaming section and select Override failover order = Yes. Leave vmnic1 active and set Unused for the vmnic0 port.

As a result, your ESXi host will use only one network interface to access your iSCSI LUN.

Configuring iSCSI Software on VMWare ESXi

The iSCSI software adapter is disabled by default in ESXi. To enable it, open Storage -> Adapters. Click Software iSCSi.

Change iSCSI enable to Enabled.

Then add the IP address of your iSCSI storage and the connection port (by default, the TCP Port 3260 is used for the iSCSI traffic) in the Dynamic targets section. ESXi will scan all iSCSI targets on the storage and display them in the Static Targets list.

Save the settings. Note that a new iSCSI Software Adapter HBA vmhba65 appeared in the Storage -> Adapters tab.

If you don’t see the list of iSCSI targets in your storage, you can diagnose iSCSI disk availability using the ESXi console.

Enable SSH on your ESXi host and connect to it using any SSH client (I use the built-in Windows 10 SSH client):

ssh [email protected]

Connection to 192.168.113.10 3260 port [tcp/*] succeeded!

true

Software iSCSI Enabled

vmhba65
Name: iqn.1998-01.com.vmware:srv-esx1-1234abcd
Alias:
Vendor: VMware
Model: iSCSI Software Adapter
Description: iSCSI Software Adapter
Serial Number:
Hardware Version:
Asic Version:
Firmware Version:
Option Rom Version:
Driver Name: iscsi_vmk
Driver Version:
TCP Protocol Supported: false
Bidirectional Transfers Supported: false
Maximum Cdb Length: 64
Can Be NIC: false
Is NIC: false
Is Initiator: true
Is Target: false
Using TCP Offload Engine: false
Using ISCSI Offload Engine: false